DiyLightAnimation
Software => xlights => Topic started by: joeengler on December 09, 2013,
-
OK,
I have xlights working on all my RGB stuff, however of the 3 Dlight controller boxes I have left for this year I can only get it to respond during play back which is the first controller.
(http://)
-
What are your d-light unit numbers? only 1-3 as unit numbers would be valid with that configuration.
-
What are your d-light unit numbers? only 1-3 as unit numbers would be valid with that configuration.
Well you may be on to something, I have unit 3, 4 & 8 and 3 is the only one that is working. when I get home I will try renaming them to 1,2 & 3 and re-export to see that fixes the issue.
-
you could also just change the xLights network config to have the last channel as 128 (8*16).
Frank
-
That would work also, but would I have to change the address on any of e131 stuff?
-
depends on where your sequences are coming from. You are probably right that is simplest to just change the unit numbers.
Frank
-
change the unit numbers to 1,2,3
-
change the unit numbers to 1,2,3
Well when I got home from, I went out and update the unit I'd on the controllers to 1,2 & 3, I also opened the sequence in LSP and changed the unit id in the sequence. I then reexport to a conductor file brought the updated file into xlights and now I have lost the only controller that was working.