DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: joshuashu on September 11, 2009,
-
Ok,
i got the controller to work sort of. i have a few bad channels 1,3 so far. here is the thing. In LSP if i set the MR 16 up as a light controller it doesnt work. but if i set it up as a RGB controller it works just fine. is this correct? if so how do i set it up? how do i make just blue come on or just red? sorry for the stupid questions but i am still very new to this.
-
Hi Joshua,
Just a suggestion
Your question is more of a software one and not a MR16 one.
I would post this in the LSP forum or even at their LSP website.
David and Ryan (programmers for LSP) do monitor this site at times but I am sure they would not see this post.
Rick R.