DiyLightAnimation
Hardware => Lynx Express => Topic started by: devoidelk on November 10, 2012,
-
Channel 5 works when i test on the LE but does not respond to any commands from the dongle.
What could be the problem?
-
Is the opto in backwards?
-
there is not an opto in the LE. But i checked all the components and there is not any solder bridges.
-
What software are you using? Do you have the channel disabled in the software for output?
Steve
-
vixen and ive gone through all channels and there all enabled
-
there is not an opto in the LE. But i checked all the components and there is not any solder bridges.
No opto?
That seems like a problem.
-
there is not an opto in the LE. But i checked all the components and there is not any solder bridges.
There are 16 of them from what I see in the manual
-
solved it was the vixen profile causing the fit... For some reason it acted as if the channel didnt exist even though i had 16 shown.... redid my profile and works fine.... ty for all the ideas
-
there is not an opto in the LE. But i checked all the components and there is not any solder bridges.
There are 16 of them from what I see in the manual
My bad i was thinking optocouplers not optio isolaters