DiyLightAnimation

Hardware => Lynx Express => Topic started by: tombmatt on July 26, 2010,

Title: channels 225 up wont lite up on test
Post by: tombmatt on July 26, 2010,

I was programing my 6 le's and when I got to channel 225 on nothing works I thought it might be the chip so I swaped chips reprogramed and still the same it is supposed to start at 218 go up to 233 but 225 on do not lite up. did it on 3 different boards did it on 2 different chips thought I had not enabled the channels and I had not bu that wasn'  it they still don't lite up any thoughts?

Title: Re: channels 225 up wont lite up on test
Post by: rrowan on July 26, 2010,

what software are you using?

Vixen, Lsp, etc

how many channels did you set up?

If you set the le to channel 1 does all of the channels work?

Rick R.

Title: Re: channels 225 up wont lite up on test
Post by: tombmatt on July 26, 2010,

using vixen and the test channels section. If i programed the le for channels 218 thru 233 I lost channels 225 on. if I programed a lower start address all channels would come on. (low enough to not use 225 up)

Tom

Title: Re: channels 225 up wont lite up on test
Post by: memphislights on July 31, 2010,

Did you setup your Enttec plugin and sequence for 512 channels?

(http://diylightanimation.com/wiki/index.php?title=Image:Vixen_Dongle_Plugin_Setup_01.JPG)