DiyLightAnimation

Software => Vixen => Topic started by: deanathpc on September 26, 2011,

Title: Timing
Post by: deanathpc on September 26, 2011,

Hello folks!  I seem to have a problem....  Just got my stuff from Holiday Coro and am using their sequences that come with the Halloween stuff.

I need to move things into my profile but the problem I just found is these sequences are done in 10 ms.  I try to make a new sequence with my profile and change it to 10 but i get an error that anything less than 25 is impractical and defaults to 25.

So now what do I do?

Dean

Title: Re: Timing
Post by: rrowan on September 26, 2011,

If you are using ss then you need to set it to 50ms

You will have to adjust the events as going from 10 to 50 is a big jump

Rick R.

Title: Re: Timing
Post by: deanathpc on September 26, 2011,

Well how can these be done in 10 if Vixen doesn't allow it?  I'm not using smart strings either....  just incans.

Title: Re: Timing
Post by: rrowan on September 26, 2011,

I do believe Xlights will play the sequence

Rick R.

Title: Re: Timing
Post by: trekster on September 26, 2011,

Create the sequence and choose 25.  When it is done saved and up on the screen then choose the drop down "sequences" then "Settings".  There choose the time as 10ms and re-save the sequence.  You then have one at 10ms.  Then cut and paste the stuff over to your new sequence.  Then go back and change the settings back to 25 or 50 etc.  Then save again.

Ron

Title: Re: Timing
Post by: deanathpc on September 28, 2011,

Well I think that did it!  I thank you!  Now to copy these over and test test test!  I'll let you know how it turns out! :)