OK here is one for the electronic guys out there, I built an Aether II programed the PIC and set the start channel successfully. Tried it out with Xlights and worked flawlessly. Added it to my show last night and noticed some weird flashing on my porch (where the Aether is) and found the Aether was randomly flashing white. disconnected Aether from DMX cable and reconnected and the Aether went out. Go back in side and a few minutes later notice Aether is flashing randomly again, this time the white is on but it is flashing all 3 other LED's too. Removed Aether from DMX and reconnected no change, so I disconnected the power (Same transformer all four of my other Aethers are connected to a 750 KVA 12 volt AC transformer) and brought it inside. This morning when I opened up the Aether I could smell something (not burnt) and noticed the top of the 6800 MFD capacitor was bulged and it has spayed oil all over the inside of the fixture. So before I get another 6800 MFD capacitor and install it is there anything I should be looking at first? As I said when I built and programmed the start channel it worked.