Got my first Aether II built up. I've got it connected up to my power supply and I reflashed the PIC fresh and verified it's correct check sum.
When I crank up the channel #1 the RED LED fires up; however, it's very DIM and probably close to the intensity of the RED when in RED flashing mode.
GREEN, BLUE and WHITE seem to fire up OK and are much more intense than the RED. However, regardless of the channel I'm using I get a flickering strobe effect from the LED PCB module. When not transmitting anything to the Aether II I get a periodic slow red blip and occasionally other colors. Just blinked green and white when I was writing this.
I've tried both pig tail inputs since I'm not sure, which one should be the correct input.
When I unplug the RJ45 cable the Aether flips over to intense steady white sometimes but not always. Just now when I did it, it was green for a bit. Then I tried it again and nothing...
Not sure how to troubleshoot this. Hopefully you will have some advice for me.
I've looked over the PCB board and do not see any bridges that are visible to me.