DiyLightAnimation

Hardware => Lynx Aether => Topic started by: Mickpat on November 16, 2011,

Title: Aether I programming
Post by: Mickpat on November 16, 2011,

I accidently used my PixnelNet dongle to try and program the start channel on my Aether.  After much troubleshooting I realized I had grabbed the wrong dongle.  Aether lights would turn baby blue.  After connecting the DMX dongle, it still wouldn't program. I finally loaded the diag firmware which worked perfectly and then reloaded the standard firmware.  Afterwards, I was able to program the Aether successfully. 

Title: Re: Aether I programming
Post by: Steve Gase on November 16, 2011,

good cautionary tale.  :)

thx