Hardware > Lynx MR16 / 16 CH DC Controller
Random Channels Work
DonFL:
A bad 7805 would not have caused you an intermittent issue, the solder connection touch-up is likely what resolved your original issue with only some of the channels working. Hard to say what caused the 7805 to go bad..or, possibly you had a cold solder joint on the regulator that was resolved with the replacement.
More importantly, glad to hear you got it going.
twooly:
I tested the 7805 after I wasn't getting power, wasn't getting the readings you should off of it. Yeah I know that wasn't related just ended up having two problems then.
The solder along the pic didn't look the best so I'm betting once I touched those up that fixed my initial problem
Thank you
RJ:
Glad you got it all working! :)
Navigation
[0] Message Index
[*] Previous page
Go to full version