DiyLightAnimation

Hardware => Lynx Express => Topic started by: sabie on November 19, 2012,

Title: dmx outputs ?????? thanks for the info that solves my problem
Post by: sabie on November 19, 2012,

can both dmx outputs be used on le version 5 and are they both the same universe????

Title: Re: dmx outputs ??????
Post by: jnealand on November 19, 2012,

Yes and the same universe.  It is kind of like a splitter.

Title: Re: dmx outputs ??????
Post by: Jeffl on November 19, 2012,

I think #1 is straight out and #2 is regenerated.  My thought is I use #1 unless I need a branch then I use #2.  #1 will pass the signal even if the power is off.  I don't think that is the case with #2.

Title: Re: dmx outputs ??????
Post by: chrisatpsu on November 19, 2012,

the only issues will be if you're bringing in your dmx via the ex attached to an Express. then DMX 1 will not work on just the Express with the EX (wireless card) attached.

if you connect your devices via the dmx2, and not use the dmx 1, then put on the terminate jumper.

you can use them both at the same time and it will act like a DMX splitter.

Title: Re: dmx outputs ??????
Post by: sabie on November 19, 2012,

thanks for the help that is what i was hoping was the case