DiyLightAnimation
Hardware => Lynx Smart String => Topic started by: jess_her on July 22, 2012,
-
Smart String controller V2 BOM looks allmost the same as V1. but there has to be a difference. Anybody know. The only thing I see is a 47 ohm resistor for V2 and 330 to 150 Ohm for the V1.
-
I know instead of 1 pin being connected to the output of the data there are 4.
-
I second wanting to know the new bom for the sscv2 pcb's. Also where is a good place to find the pigtails? Connectors?
Grant
-
I would further be curious if swapping those two resistors, tying in the other three outputs and loading the V2 programming on a V1 chip would then effectively get you a V2 SSC.
Probably beyond the technical discussion limitations of the forum, but it would be interesting to have a simple 'yes' or 'no' to this supposition.
-
No
Rick R.
-
Sorry my question wasn't worded very well, I was looking for smart string controler V2 BOM.
-
Sounds like you found it. The resistor was changed and the pcb and firmware was changed.
RJ
-
thank you RJ
-
Link for the BOM has been added to the wiki
Thank RJ for the url
Rick R.
-
Looks like the wiki link sends us to the BOM of the SSR4 V2 Complete.
:(
-
Looks like the wiki link sends us to the BOM of the SSR4 V2 Complete.
:(
What does that mean?
Rick R.
-
Looks like the wiki link sends us to the BOM of the SSR4 V2 Complete.
:(
What does that mean?
Rick R.
It means that SSC V2 MOUSER BOM link on the wiki actually links to the SSR4 V2 BOM.
here is what the current SSC V2 BOM link goes to
https://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=5250caa9af (https://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=5250caa9af)
-
The SSC v2 parts list link on Wiki has no SSC V1 OR V2 parts on it.
<fp.
-
Greetings,,,
It'll be switched to the correct link. Sorry for the confusion.
Keith
-
No worrys.
At least I saw that. ::)
I still have hope.
Mort
-
Sorry about that folks
The link has been corrected and ready for use
Rick R.