Hello all, I just finished my first Lynx Express v5 build and when I plugged it in the display said Lynx Express 60 hz however,channel 6 led lit up dimly and when I ran it through the test, channels 6, 10,11 and 12 leds did not light up. However after the test channel 2 and 4 lit up as they are supposed to. My solder joints all look decent, and if anything shouldn't have worked , it would be the middle digit where I didn't realized I was using my thicker roll of solder and it got a little ugly, but lo and behold it works! Any ideas what it might be?