DiyLightAnimation

Fun => The Porch => Topic started by: wwwgator on July 21, 2015,

Title: any taylor swift fans/ PixMob
Post by: wwwgator on July 21, 2015,

Hey everybody...
My daughter and the Mrs went to the Taylor swift show in Chicago over the weekend.....and came home with these fancy bracelets from pixmob. there are 3 RGB leds inside with a IR reciever inside.
Has anybody been able to control these without using the pixmob controller? Acording to pixmob web site http://pixmob.com/technology/
it sends dmx to IR fixtures to activate the bands.

I think it would be awsome to "wake up" their bands and make them blinky blink
with out doing the bump mod on them.
 This is from a forum i found...

Apparently, they control the bracelets during the show, then send a "end of show" signal to activate/program  a motion control mode (?) I personally havent seen it yet or tried it....I'll get home today and check it out


Thanks...as always....
-W

Title: Re: any taylor swift fans/ PixMob
Post by: wwwgator on July 21, 2015,

Ok, quick update...
 I spoke with the Mrs.
 She tells me that they did send out the end of show program that made the bracelets motion activated.
So the question is ......can you change it back to a controlled bracelet?

Title: Re: any taylor swift fans/ PixMob
Post by: meman on July 24, 2015,

Try a universal remote control.
https://www.youtube.com/watch?v=Z2i7aO0yx3g