For some reason my previous post is messed up and I cant see it.
I am trying to program my pic and I am not being successful.
Here is what I am doing.
I have the pickit 2 and software
I have a 28 pin board and a connect wire from the board to the programmer
I open the software and connect the programmer.
I check the communication and it say pickit 2 found and connected.
I than run the download pickit 2 operating system and it says pickit found and connected after it resets.
After all of this, I try to read the pic and it says no device detected. I also cant open up the hex file either.
On my board which is the j1sys board that is recommended, I have the pic in the slots, the lever down, and the connector cable attached. I dont have any terminators on the board. I think this might be my problem but am not sure. I can send a picture if wanted, for some reason it wont let me post a 804 kb picture on here.
Thanks in advance
Brad