I think all these methods shown look good.
My rather created a rather elaborate jig to rip 1/2 conduit ... process is basically to (1) drill the holes, (2) run through table saw twice to rip a slit down the middle. The lights go in the back and the pvc itself clamps onto the nodes. Does require a screwdriver open up the slit to insert each node, but then holds it super well. Don;t recall the exact drill bit size used, but its changing as nodes this year are slightly more elliptical than in years past.
This process is more labor intensive than others shown and probably only a certain percentage better at the end of the day. We did install the entire rooflines of both homes in under an hour.
These 1/2 conduits then store in a rack in my garage.
You are not allowed to view links.
Register or
LoginYou are not allowed to view links.
Register or
LoginYou are not allowed to view links.
Register or
LoginYou are not allowed to view links.
Register or
LoginYou are not allowed to view links.
Register or
Login
