DiyLightAnimation

Hardware => Lynx Aether => Topic started by: wbuehler on November 11, 2010,

Title: Build Tip
Post by: wbuehler on November 11, 2010,

I went to Lowes and had them cut two pieces of Lexon for me.

One at 1" wide the other at 3/4" wide to use as a guide.

Bill

Title: Re: Build Tip
Post by: jnealand on November 11, 2010,

This does not help me.  What is it used for?

Title: Re: Build Tip
Post by: wbuehler on November 11, 2010,

The one inch and 3/4 measurements used to mount the Side Pieces of angle to the case.

Bill

Title: Re: Build Tip
Post by: wbuehler on November 12, 2010,

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Title: Re: Build Tip
Post by: rdebolt on November 12, 2010,

You are not allowed to view links. Register or Login

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

Title: Re: Build Tip
Post by: batdive on November 12, 2010,

You are not allowed to view links. Register or Login

You are not allowed to view links. Register or Login

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

Here you go...  

Pin 1 (top left pin) is empty
Pin 2 (Signal Wire ) In this case white wire if using servo extensions
Pin 3 (+5)  Red wire
Pin 4 empty
Pin 5 (Bottom right pin) ground
Pin 6,7,8 empty

Title: Re: Build Tip
Post by: rdebolt on November 12, 2010,

You are not allowed to view links. Register or Login

You are not allowed to view links. Register or Login

You are not allowed to view links. Register or Login

It's a little hard to see due the limited surface area to print the silkscreen onto.
Here is a pic that shows the pigtail being attached to the Aether.


Looking at the back of the board from left to right:

1.  Ground (-)
2.  Power (+)
3.  Signal

Hey Bill,

Nice picture and great idea on the lexan.  How about a picture of an ex\rx? I've never done this mod and want to make sure that I get it right.

Thanks,
Roger

Here you go... 

Pin 1 (top left pin) is empty
Pin 2 (Signal Wire ) In this case white wire if using servo extensions
Pin 3 (+5)  Red wire
Pin 4 empty
Pin 5 (Bottom left pin) ground
Pin 6,7,8 empty

Perfect! Thank you!