DiyLightAnimation

Hardware => Lynx Aether => Topic started by: smartcontrols on October 27, 2011,

Title: Aether II troubleshooting question
Post by: smartcontrols on October 27, 2011,

It looks like there may be some type of test function built into the Aether II, not sure. I can not locate any info on it yet. One of my new Aether II cycles from red to blue to red…… This also happens with no DMX connected. Does any one know what this means? A point to any troubleshooting or testing info would be helpful if you know of one.

I will continue playing with it.

Thanks
Jeff

Title: Re: Aether II troubleshooting question
Post by: rrowan on October 27, 2011,

I think one of the switches does that

Rick R.

Title: Re: Aether II troubleshooting question
Post by: RJ on October 27, 2011,

Are they all doing this or just one of them. I have a test firmware that does this but it should not be what is loaded.

RJ

Title: Re: Aether II troubleshooting question
Post by: smartcontrols on October 27, 2011,

Quote

Are they all doing this or just one of them. I have a test firmware that does this but it should not be what is loaded.

Just one.
After I saw it doing it. I reflashed the pic with the hex in WIKI. same thing.

Quote

I think one of the switches does that

If I change the program switch the other way it goes bule and stays blue.

Admins:
I think I may have posted this in the wrong section. You may want to move this to the Troubleshooting section. Sorry