DiyLightAnimation

Hardware => Lynx Aether => Topic started by: inzeos on November 12, 2011,

Title: Aether II - Pig Tails
Post by: inzeos on November 12, 2011,

I'm making an assumption we strip back as needed the jacketing from the cut end of the pig tail.  Then stripping back some insulation off the white/orange and orange wires.  Then each one of the pigtails gets soldered in with one orange/white on the top and one orange on the bottom for each pig tail?

Title: Re: Aether II - Pig Tails
Post by: onesmoothhead on November 12, 2011,

This is correct.  I coiled the rest in case there ever was a future need.  With RJ you never know.


Kevin

Title: Re: Aether II - Pig Tails
Post by: inzeos on November 13, 2011,

Is left or right the input?

Title: Re: Aether II - Pig Tails
Post by: inzeos on November 13, 2011,

Which pigtail connection should be the DMX IN vs the DMX OUT?

Title: Re: Aether II - Pig Tails
Post by: Steve Gase on November 13, 2011,

There is no difference between the two.  The second connection is for convenience to allow you to connect more DMX devices in sequence.