DiyLightAnimation
Software => Light Show Pro => Topic started by: travailen on November 14, 2012,
-
When I start LSP I can play the sequence and the lights blink. When I make a change to the sequence, the change is ignored and the lights blink as before the change. When I save the change I made to the sequence, the lights no longer blink when I run the sequence. To get the lights to blink, I have to close LSP and restart it. Then when I run that sequence, the lights blink according to the changes I previously made.
This is not the best way to program. Any help would be appreciated.
I am running a Toshiba Qosmio 64 Bit windows 7 laptop with LSP 2.5.4683.24392 in professional mode.
Thanks,
Rick S
-
Right click in the audio area and choose to optimise the whole sequence.
Sent from my Thunderbolt using Tapatalk 2.
-
Thanks, that helped. Now I just optimize after every change or every save.
Another question. The red on the sequencer makes green lights and the green on the sequencer makes red light. To fix that I have to set my controllers to GRB. is correct or am I just masking a problem?
Rick S
-
What kind of rgb? I have seen this on smartstrings if you choose the wrong type of node while programming the ssc.
Sent from my Thunderbolt using Tapatalk 2.