DiyLightAnimation

Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: joshuashu on September 11, 2009,

Title: questions
Post by: joshuashu on September 11, 2009,

Ok,

i got the controller to work sort of.  i have a few bad channels 1,3 so far. here is the thing. In LSP if i set the MR 16 up as a light controller it doesnt work. but if i set it up as a RGB controller it works just fine. is this correct?  if so how do i set it up? how do i make just blue come on or just red? sorry for the stupid questions but i am still very new to this.

Title: Re: questions
Post by: rrowan on September 11, 2009,

Hi Joshua,

Just a suggestion

Your question is more of a software one and not a MR16 one.

I would post this in the LSP forum or even at their LSP website.

David and Ryan (programmers for LSP) do monitor this site at times but I am sure they would not see this post.

Rick R.