DiyLightAnimation
Hardware => Lynx Wireless DMX => Topic started by: z327 on September 25, 2010,
-
Is the case correct in the WIKI for the Version 2 TX/RX?
Case (Choose Gray and put in the comments of the order "Make Sure it has the PCB bosses" ) http://www.polycase.com/item/lp-51p.html
I purchased this case and it appears to be too big for the TX/RX Version 2 and the bosses don't line up.
-
Not sure about the one you ordered I had a case lying around from a ver 1 TX/RX that didnt get dont and my ver 2 TX/RX fits great in it. It was the same as the dongle case, which per the wiki is this one:
http://www.polycase.com/item/lp-35p.html
And the bosses fit great after you cut the cat 5 plug out so it slides into the hole.
Hope that helps...
-
Not sure about the one you ordered I had a case lying around from a ver 1 TX/RX that didnt get dont and my ver 2 TX/RX fits great in it. It was the same as the dongle case, which per the wiki is this one:
http://www.polycase.com/item/lp-35p.html
And the bosses fit great after you cut the cat 5 plug out so it slides into the hole.
Hope that helps...
Be careful here. There are two different cases for Ver1. The TX and the RX cases are not the same size. The RX is a bigger case. I have 3 of them that I don't need since I sold my PCBs off. Anyone who wants these 3 V1RX cases can have them for my cost, plus shipping and paypal.
-
Not sure about the one you ordered I had a case lying around from a ver 1 TX/RX that didnt get dont and my ver 2 TX/RX fits great in it. It was the same as the dongle case, which per the wiki is this one:
http://www.polycase.com/item/lp-35p.html
And the bosses fit great after you cut the cat 5 plug out so it slides into the hole.
Hope that helps...
Then the wiki is wrong. It lists the LP-51
http://www.diylightanimation.com/wiki/index.php?title=BOM#.23Wireless_RX
-
Not sure about the one you ordered I had a case lying around from a ver 1 TX/RX that didnt get dont and my ver 2 TX/RX fits great in it. It was the same as the dongle case, which per the wiki is this one:
http://www.polycase.com/item/lp-35p.html
And the bosses fit great after you cut the cat 5 plug out so it slides into the hole.
Hope that helps...
Then the wiki is wrong. It lists the LP-51
http://www.diylightanimation.com/wiki/index.php?title=BOM#.23Wireless_RX
I made the change. Somebody just did a copy and paste and didn't update the case number
Rick R.