DiyLightAnimation
Hardware => Lynx SSR4 => Topic started by: lightingboy82 on November 07, 2011,
-
How do i program the PIC on the SSR4, since it doesnt have an ISCP port like the express and other boards. I thought about putting the PIC in the express, and loading it that way, then i came to my sences and saw that this PIC is not the same as the others. ALSO, how do i program the DMX start address....i dont have a DMX dongle...do i need one to do that? i dont need it to get DMX as i am using another controller.
-
You need a programming socket for it. You can either buy one (where the popular option is j1sys http://www.ebay.com/itm/ICSP-Adapter-ZIF-18-20A-pin-PIC-use-PICkit-2-3-/330401301106?pt=LH_DefaultDomain_0&hash=item4ced73c272#ht_1228wt_1141) or build one like in the wiki
http://www.diylightanimation.com/wiki/index.php?title=Bare_bones_PIC18F_programmer_interface
Rick R.
-
thanks!!! i have a pickit 2...should i buy a 3? I noticed this diagram is for the 3, and also its noted in the ether dongle to use a 3... i wish i found out about this site earlier and could have gotten in on the coop oh well.
-
oh yeah and about programming the dmx channel address.... can i do that with the pickit2 or do i need the dmx dongle...
-
You are fine with the 2 until you get a etherdongle, all other lynx hardware at this time is fine with the pickit2 or pickit3. The person who did the drawing has a pickit3 so that is what they shown.
The program the start address you need to use the dongle and RJ's lynx address utility.
Follow the directions in the manual and you should be fine
Rick R.