DiyLightAnimation

Hardware => Lynx Smart String => Topic started by: trekster on July 21, 2011,

Title: Smart String Test Firmware
Post by: trekster on July 21, 2011,

I used the lynx ss utility to program my first string.  It worked.

Now I want to use the test firmware and do a burn in for my strings.  QUESTION:

Do you need to still program the strings with the ss utility for start address, forward or backwards hybrid mode etc....  if you only want to use the test firmware?

Or just put on the test firmware and plug the strings into the hub?

Ron

Title: Re: Smart String Test Firmware
Post by: skulldan on July 21, 2011,

you just need to flash the test firmware and plug into hub for power.

Title: Re: Smart String Test Firmware
Post by: batdive on July 21, 2011,

Trek, best thing I found was to do the test firmware for however long you want your burn in period first, then after that install the latest firmware and go through the SS util and set up the node count and type of set up for final configuration


-JS

Title: Re: Smart String Test Firmware
Post by: trekster on July 21, 2011,

Thank You!   ;D

Ron