Here is mine. I had lots of left over pvc pipe pieces from making props. I noticed the little v grooves in the ends of the box. Cut two pieces of pvc to be an exact fit. Just screwed one side of the board to one piece of pvc since the holes would not line up, but it turns out that works pretty good because if I need to reach under the board to turn off power I can just pivot the board up and don't have any problems with the length of the cords on the power supply. This photo is the one at my workbench, but all of my boards are mounted the same way. The blue tape on the board is where I have blown the fuses while testing. I guess I should fix those since this is my backup unit and I use 15 ports on my outside active hub.