Where do I order RJ45 Pigtails

[sittinguphigh]

Thanks Steve.

 That's what I needed some one that used them.
 I only will be using 4 SSC. But that means I can't have any go bad.

 Thanks

 Mort

 

[chrisatpsu]

have all the pigtails from this year's coops are wired the same? (solid vs stranded and all still straight through cable?)

i'm building my ssc's and aetherII from the recent coops, and don't want to make a wiring mistake.

[Steve Gase]

have all the pigtails from this year's coops are wired the same? (solid vs stranded and all still straight through cable?)

i'm building my ssc's and aetherII from the recent coops, and don't want to make a wiring mistake.

i've gotten into the habit of testing the colors with each 4-conductor, 3-conductor, or pigtail connector with each batch of kits or parts i receive. 

better safe than sorry.
an ounce of protection is worth a pound of cure.
measure twice cut once.



 

[jnealand]

i've gotten into the habit of testing the colors with each 4-conductor, 3-conductor, or pigtail connector with each batch of kits or parts i receive. 

Probably a good habit.  I did receive on 3 connector pigtail that had the blue and brown wires switched.  After unsoldering and testing I just swapped the wires since that was easier than trying to send one back for exchange and it does work fine with the wires swapped at the solder joint.

[sittinguphigh]

Steve

What are the pigtail jacks you used instead of the keystone jacks?

Mort

[keitha43]

They come in the coop or you can pm RJ to purchase some.

Sent from my Thunderbolt using Tapatalk 2.

[RJ]

The store replaced pm me for ordering stuff.

I do not have any at the moment. Soon as they come in they will be listed in the store.

RJ

[Penfold]

I saw some on ebay.  This might be what you are looking for:

You are not allowed to view links. Register or Login

Cheaper here:

You are not allowed to view links. Register or Login

But with that one you are going to have to figure out what the pin out is and accordingly adjust that when you solder it in the board.