DiyLightAnimation
Hardware => Lynx MR16 / 16 CH DC Controller => Topic started by: Ozmin on December 13, 2011,
-
Hey Guys - Was wondering about the placement of the caps and resistors (16 ea.) that go above the 16 transistors. Does it matter which goes where? I know each transistor gets one of each, but I installed the the 1uf caps towards the left when looking on the bottom side of the board. Wanted to know because I do not want to have to de-solder 32 parts instead of just 16. I hope it does not matter which goed where......
Thanks - Bill A.
-
It does not matter. They are "parallel" path components.
-
I am guessing you put this in the wrong area.
Rick R.
-
Rick / JonB256 - My bad on placement of the post. Late night and tired. Thanks for the reply. I thought it was a non-issue on placement, just wanted to make sure. Thanks again for the help.
Bill A. :)