DiyLightAnimation

Hardware => Lynx Express => Topic started by: JerryPlak on May 21, 2018,

Title: Question about the Lynx Express and the Express Receiver..
Post by: JerryPlak on May 21, 2018,

Does anybody know the current limit of the Lynx Express board running the Express Receiver,

My plan is to run a ESP-RS485/DMX board instead of the Express Receiver.

It looks like the ESP-RS485/DMX board 500 mA to run or or run it externally from his own power supply.

Any thoughts
thanks
Jerry

Title: Re: Question about the Lynx Express and the Express Receiver..
Post by: cmorda on May 27, 2018,

I run an ESP8266 module from the 3.3v rail. It averages 80mA but has tiny peaks of 400mA (less than a microsecond).

In practice, it runs fine. If I remove and replace the module while the LE is running, the LE will sometimes reboot. That makes me think that I could be on the edge of the power supply's ability to keep up with the demand (at 3.3v). Adding a decent size cap would probably prevent that.

You might want to look at my post about it. I designed a tiny PCB with no components needed (just header pins). Its simple and extremely inexpensive, and has a large install base in a slightly different application.

Title: Re: Question about the Lynx Express and the Express Receiver..
Post by: cmorda on May 27, 2018,

http://diylightanimation.com/index.php?topic=15809.msg185382#msg185382

Title: Re: Question about the Lynx Express and the Express Receiver..
Post by: JoeFromOzarks on May 28, 2018,

You are not allowed to view links. Register or Login

If I remove and replace the module while the LE is running, the LE will sometimes reboot.

Yea, maybe ye wanna look in the DLA Equipment Wiki under “Hot Swapping.”  :) :)

:) joe

Title: Re: Question about the Lynx Express and the Express Receiver..
Post by: JerryPlak on June 04, 2018,

You are not allowed to view links. Register or Login

http://diylightanimation.com/index.php?topic=15809.msg185382#msg185382

cmorda,
Thanks for the info  8)
Jerry