OK...
First I will try to explain my setup then I'll explain my issue.
I have two SSC driving strings of nodes. one has 120 nodes the 2nd has 105 nodes.
I am running them end to end to make one long string of 225 nodes.
When I program the channels onto the nodes 1 am starting with channel 1 and going to channel 315 for the 105 node string then continuing with 316 and going to 675 for the 120 node string.
I have a simple sequence set up in vixen that starts with node 1 turning red then node 2 turns red and 1 turns green. this progresses so that each node cycles red green blue white while the one behind it is one "step" behind.
my issue is...
when the sequence transitions from string 1 (with 105 nodes) to string 2 (with 120 nodes) the progression brakes and it doesn't follow sequence. It seems as if the 2nd string is a few channels behind.
I first thought that my sequence was messed up but it doesn't appear to be.
And I have switched the order of channels end for end (120 node string starting channel 1 and 105 node string starting channel 361) and the progression brakes when it switches strings (but this time at channel 360-361 not 315-316 as it was with the 105 node string first)
I have also run one forward config one backwards (same result) and both backwards (same result)
I have also programmed both strings to start channel 1 and that works also so I don't think there is a bad node in either of the strings.
If I overlap the channel programming by one node (first string ending channel 315 2nd starting 313) the progression works.
I am baffled. I hope it is something simple and I am overlooking something easy or I am having a bonehead moment.
my sequence
is would be attached but cant upload .vix file extension