I can not get the nodes to light. At first I had a string of 20 and I could control them in Vixen. I then took all controllers and flashed with the test firmware for burn in testing. That worked fine. I then reflashed with pickit 3 to the Smart_StringController2-7-10-011.hex. I can then verify that it is at E363 checksum. Then I open the SS utility and choose start channel 100 (tried 1, 500, 523 etc), pixelnet dongle, 20 nodes, hybird, square nodes etc (watched RJ's video 3 times) and press program with the jumper on. All the nodes blink fast like in the video. I then click stop, pull the cat5 plug, lights go out, move jumper off. I open up vixen. I have the com port set correct. I have a test sequence with ALL channels on. I then play the sequence but no lights light. I have an express connected to the dmx out. It works. All lights come on. If I play a real sequence the lights on the express light and dance correctly. The channels are set to 1-4096 in the pixelnet plugin.
I can re flash the ss controller with test firmware and then work. Yes I have the pixelnet plugin loaded in Vixen. I have a blinking green light on the pixel dongle and a red power light. All is working but I can not get lights to work in pixelnet mode in vixen??
What did I over look?
Ron