DiyLightAnimation
Hardware => Lynx Wireless DMX => Topic started by: ponddude on August 14, 2010,
-
Out of curiosity, do the Version 2 cases have holes for the LEDs? Why? Well I was soldering up my TX/RX's and didn't know if I should mount the LEDs flat on the board or leave them up so I can bend them.
Just wondering ???
-
Out of curiosity, do the Version 2 cases have holes for the LEDs? Why? Well I was soldering up my TX/RX's and didn't know if I should mount the LEDs flat on the board or leave them up so I can bend them.
Just wondering ???
Leave them up a bit so they can be bent over, the version 2 cases will have two holes for the LED's
Bill
-
Thanks Bill...I figured as much