my conductor is not connecting. these are the things that i am reading about threw the forum but i wanted to start my own thread instead of hijacking someone elses.
1. the sequences from xlights makes a .xseq file extension. is that correct?
2. to create a password, the conductor has to connect with the conductor control panel correct? it won't allow me to create a password. if i leave the conductor connected, the time eventually syncs up, so wouldn't that indicate that it is connected?
3. how do i create a .sho file? i have converted all my sequences using xlights, i created a schedule threw xlights, there is no profile option with xlights so i have my vixen profile, of course password is discussed in question 2. all of my names on the cf card were renamed prior to being installed on the cf card.
4. all of the pins on my cf socket are solid(after i fixed them). i have no solder bridges, but i have continuity across several pins that are no where close to each other. .59 between pin 1 and 12,13,14 etc. there is no continuity between any pins that are right next to each other. the one place that it looks like there was a solder bridge, there is no continuity between those two pins. all of the pins have continuity from the pad on the pcb to the 90 degree bend going to the card.
my conductor still isn't connecting please help
duane
ED worked fine prior to adding firmware for conductor