Display reads 324

[goldharper]

I have an issue with my Lynx Express board. On power up the display goes through to "Lynx Express 60Hz" but then it says 324. When I first built the board a couple months ago, it read 000 after the power up sequence. Haven't powered it up since then. Nothing is different from before. What would cause this? I also had a question of when powered up, led 6 is dimly lit and when running test, brightness of led 6 doesn't change and led's 10, 11, & 12 don't light at all, but from reading other topics, have came to the conclusion that the pic needs re-flashed.

[tbone321]

since it is giving you a start address without you settig one, I would suggest a reflash as the first step.

[rm357]

Dim led 6 is a sign of a bad firmware load.
If the character scrolling seems slow, that is also an indicator of a bad firmware load.

Other things can cause these signs, but reloading the firmware is the easiest and usually fixes The problem.

[goldharper]

My next step to take is to reload the firmware. I got the board and hardware in the coop in January of this year and have heard that there were a lot of problems with the firmware that was loaded on the pic and reloading the firmware fixed the problem. I'm still confused as to why it is giving me a start address when it wasn't before, but oh well. I'll just give reloading the firmware a try and see if it fixes the issue. Thank you.

[DanHouston]

Had this exact issue on two boards my dad and I just completed....a reflash of both resolved it.