DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: frankr on March 25, 2012,
-
Hello all,
I was looking on the Wiki for an etherdongle BOM but could not find one. I need to know the part number for the ethernet jack. One of the pins broke on the one in my kit and I need to get a replacement.
Frank
-
the magjack should have...
two plastic stems
2 outside metal stems.
4 pins in the front
7 pins in the back
compared to the other jack, it looks like it's missing a pin. but it's correct in having 7
unless you actually broke one of the pins from above, this is a common scare at first.
-
I believe they added to the manual pointing this out to help keep people from thinking this. There is only seven on everyone of them.
RJ
-
Lol go fig. I didn't look before installing only after pulling it out. I need to reexamine when I get home as I could have sworn there was a hole and trace where I had no pin...
-
There is a hole but no trace. The hole is part of the part pattern and I left it in case we have to sub the part some day as some of the replacment parts would have the pin it just does nothing.
RJ
-
Sometimes it pays to be a little slow on building the kits. I would have probably thought the same thing and pulled the jack for no reason.