DiyLightAnimation

Hardware => Lynx Smart String => Topic started by: trekster on July 24, 2011,

Title: Connecting nodes to the SS Controller.
Post by: trekster on July 24, 2011,

ALL LOADED WITH TEST FIRMWARE

I have 6 sets of rectangle nodes connected and they are all
Red +
Blue -
Green data

I have 1 set of square connected
Red +
Blue -
Green data

I have one set of regular nodes connected the same as above to the side with one big IC Chip.  I tried the other side also.  NO Blinky?

Are the colors the same on the regular nodes?

I will try another controller if the colors connect the same.

Ron

Title: Re: Connecting nodes to the SS Controller.
Post by: rm357 on July 24, 2011,

Colors are swapped.

Regular ss pixels are
red = +
Green = -
Blue = data

RM

Title: Re: Connecting nodes to the SS Controller.
Post by: trekster on July 24, 2011,

Thank you!

You got to love it when a guy's nodes blink  ::)

Thanks for the info.  I have blinky on my regular nodes now  >.d9

Ron

Title: Re: Connecting nodes to the SS Controller.
Post by: rm357 on July 24, 2011,

Did you say Rudolph has a cold?

His nodes blink...