Hello everyone. I was not sure where to place these comments, but after much testing i believe it should be in Ethernet area. I will refer to the pictures attached.
First, the green light at node 207 is always on and the node works fine in all the channels. It has been on since the day I received them from Ray. I call it my power light. It functions normal and I can tell I have power out of the hub.
Node 341, pictured with green and blue always on very dim, does not respond to channels commands very bottom of picture. Node 171 shown in the picture red dim always on, responds to blue commands, but does not work on red or green channel commands. Node 170 shown in the picture with blue dim always on, does not control, green and red respond to commands. I have set to separate ssc to the same start channel and both demonstrate the same node issues. All of this happens when I set Vixen to EtherNet settings in the manager.
The second picture with only the ever shinning green light is the same board, but controlled with Pixelnet through the USB dongle. I have zero node issues and everything works as it should.
I am using the same hub, ssc and power supply. The only change was in vixen under the manager. Any ideas?