Hardware > Lynx MR16 / 16 CH DC Controller

MR 16 pic programming issue.

(1/3) > >>

SteveMaris:
I am trying to set a starting address on a MR 16. It wont take an address.
I decided to try to re flash the pic with a pickit 3. I have the correct 20a adaptor. I have the dot of the pic lined up with the 18 arrow on the adaptor. I selected the 18f1220 pic on the pickit program drop down box.
No matter what I try, I keep getting a "no device detected".
What am I missing here, can someone tell me? Are any of the jumpers supposed to be used with 20 a adaptor? I am at a loss...

frankr:
try:
tools->check communication

It is the pickit that it cannot communicate with.

Frank

chrisatpsu:
click the mark to apply power to the pic.
if it's the pic i'm thinking of, it should be programmed and set for channel 1

SteveMaris:
You are not allowed to view links. Register or Logintry:
tools->check communication

It is the pickit that it cannot communicate with.

Frank

--- End quote ---
Tried this it says found pickit 3 and the serial number. I then try read, write, erase etc...
and get no device found.

SteveMaris:
You are not allowed to view links. Register or Loginclick the mark to apply power to the pic.
if it's the pic i'm thinking of, it should be programmed and set for channel 1

--- End quote ---
Not sure what you mean by click the mark.

Navigation

[0] Message Index

[#] Next page