DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: Rogelio on January 04, 2012,
-
I hope I'm not asking a stupid question but I'm not clear on this since Im so new to it. Does the Lynx hardware use a "standard" dmx protocol, or is it proprietary only to lynx??? Can Lynx dongle talk to other dmx devices and vice-verse?
I have searched for a definite answer but could not find one in the wiki or posts.
I did use quotes around standard because I know in communication protocols, standard is a dirty word. :)
I really mean a commonly used protocol.
Thanks
Roy
-
Yes,
regular good old fashioned DMX. 8)
-
thanks Steve.
-
To add to what Steve said, the Lynx Dongle uses the 1st pair (white/orange, orange) on the Cat5 cable, so you just have to make sure whatever hardware you are using also uses that pair, or you will have to make a cable to move that pair to whatever pair your hardware uses. Like the LOR hardware uses different than that.
The Etherdongle uses all 4 pairs, so if you use that, again the same would apply, you might need to make a conversion cable. also there is a combiner/splitter that RJ makes that you can use to split the 4 pairs back into using just the white/orange, orange pair.