DiyLightAnimation
Hardware => Lynx Aether => Topic started by: shaunkad on October 25, 2011,
-
I got my Aether kits I have a few questions. What does switch 1 and 2 labled sw1 sw2 do? in the top right corner is a symbols that looks to be a 2 pin header for a jumper labled Man. Is this still in use and should there be parts for it ?what is the fuse rated at?
Thank You
Shaun
-
Sw1= terminate
Sw2= program/run
fuse is 7 amp
Man spot on PCB still unknown
-
On the original Aether, it was to wire up a switch so that you could turn it on "manually" and use it as a spot light as needed without a computer or dongle. I assume this one is the same. Just an assumption though.
Thanks,
-Keith
-
What is the part number for the power supply for thr Aether 2 and how many units will it run? Where is the best place to get them?
Ken
-
I just bought a Landscape Transformer from home depot.
After figuring in the shipping(these things are heavy) it is as cheap as mail order and I can take it back if I have problems and get another one.
Heres what I got :
http://www.homedepot.com/h_d1/N-5yc1v/R-202059606/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053
I believe it will run all of my aethers.
RJ
RJ also post an estimate of 30 watts per Aether 2 but that might of changed
Rick R.
-
I added the transformer info to the wiki
Rick R.
-
I picked up one of those from HD yesterday and it's powering my first built Aether II as we speak. I'm working under the assumption that it will power the 4 Aethers I picked up in the coop. So far, so good.
-Mike
-
It was 40 watts per Aerther
-
The led is rated 40 watts but that would be all 4 colors on at the same time. The aether will not turn them all on only three. I am using 35 watts per as a safe level.
RJ
Sent from my Charge by Tapatalk
RJ