Hardware > Lynx Express

No Power

(1/10) > >>

Tigman009:
I am really new to this so be nice.  I just finished my first Dongle and Lynx Express.  The dongle works just fine but for some reason when I applied power to the express  on the LH power input I get nothing.  No lights at all.  I took my volt meter and tested the two wires going into the PCB and found 120 v on the terminal ends.  I also swapped the power leads just in case I had them backwards but still nothing.  I checked the fuse with the OHM meter and it is good too.  Where do i start?  Thanks in advance
Mike

Tigman009:
just a note...I tried power on the RH side too.  Still nothing

rrowan:
Hi Tigman009

First thing I would suggest is to take pictures of both sides of the board and post it.

If you apply power to the LH power it should power up the board and the power indicator LEDs. 3.3v and 5v

I would guess its either some solder problems and or parts in wrong.

Rick R.

Greg:
You might want to check the orientation of the bridge rectifier (top left corner of the board).


Greg

RJ:
Made any headway?

How can I help?

RJ

Navigation

[0] Message Index

[#] Next page