DiyLightAnimation
Hardware => Lynx EtherDongle => Topic started by: ghethco on July 27, 2013,
-
Just finished assembling my EtherDongle. I have a Pickit 3 programmer on order. The only other thing pending is the power supply. I may have misplaced something, but I didn't find one with the parts I got from the coop. Was there supposed to be one? I would have just asked the coop manager, but I also found that the instructions didn't mention the power supply at all, so I'm a bit mystified. I did find a reference in one of the noob help posts that it is 6V, 0.8A. I can buy one of course, but I'm a little surprised that at least the specs aren't documented in the instructions, leading me to believe that either 1) it was in with the coop parts and I misplaced it or 2) you don't even need one. I know the USB dongle is powered through the USB, but I don't think it is possible to power a board through ethernet.
Gary
-
[blush] Never mind. It is listed in the BOM near the end. I found it mixed up with some of my DIY drones stuff. Too many hobbies :-)
Gary
-
Those drones will get you every time. LOL
-
I did find a reference in one of the noob help posts that it is 6V, 0.8A. I can buy one of course, but I'm a little surprised that at least the specs aren't documented in the instructions
I know you found your power supply, but I figured I'd go ahead and post the specs off mine:
Input: 120VAC 60Hz 15W
Output: 6VDC 1000mA
1/8" plug (black)
Jamie
-
Where did you get the pickit3 from?
-
http://stores.ebay.com/Joshua-1-Systems?_trksid=p2047675.l2563