I'm having a problem with LSP2 locking up when "enable" the output and play the sequence.
Here is what I did:
1. Enable the output.
2. Play the output (DMX signal was sent to Lynx express, but there was a huge delay), so then
3. I click on the "Stop" button, at this point, LSP2 lockup and would not response.
I end-up using the "End Task" to force close LSP2.
Please help!!!
I have tested all three controllers using the LSP feature (right click on controller and go to to test Controller hardware). Everything was working in hardware test mode.
What is going on. I just purchased this software yesterday. I hope i'm not wasting my money on this.
Please help!!!!
My Setup Info as follows:
Windows 7 64bit
LSP2 - 2.0.11271.743
3 Lynx Express
Lynx Dongle