DiyLightAnimation
Hardware => Lynx EtherDongle => Lynx Conductor => Topic started by: lburnham on December 15, 2012,
-
I’m trying to run the etherdongle controlled from the conductor which is then connected to the smart string hub to convert to dmx. I then have the hubs converter to dmx connected to the wireless dmx tx which then connects to the Lynx Express. The only problem is i can't get the smart string hub to convert pixelnet to dmx and the wireless dmx tx doesn't see the hub. I had programmed the etherdongle with the conductor firmware and I programmed the smart string hub with the latest firmware on the Wiki. Any suggestions?
-
Did you ever have dmx to the transmitter without the conductor?
-
Is this a all or nothing attempt, or do you know that some of the parts work?
Do you have the correct firmware loaded into the etherdongle and the pic on the hub?
Have you programmed a sequence and loaded it into the flash card using the utility?
How do you have the jumpers set?
...
...
...
...
...