Well, Thank you, I knew something was up when I saw the drop down for all the chip types. Two other things, first , I am having a carpel tunnel release done on my right hand Friday morning. Secondly, I inspected the board again and I found I folded a pin under the IC, CRYSTAL OSC, 32.768KHZ, 5.5V chip. It broke when I tried to move it straight. So I ordered a new one ( this chip was the one that came with the coop, I did not order it when I reordered new parts) so I am waiting on that to arrive. It has thin pins and doesn't like to be removed and re installed. I may wait till I am off pain meds before firing up the iron again. I thought this would be a good project to do while I have been recovering from back surgery, but I have been doing less then my best work. Attached are some of my welding and a shot of the front. The wires attached to the back are to replace the damaged wire runs. There are no shorts or bridges ( I checked with my meter before going on) The chip socket had a shorted folded pin and had to be taken off to correct it.
If it is alright with you RJ I will PM you when I have my replacement chip and can do the work.