I've built 4 of my 6 Lynx Express boards. When I connect the express to power - JUST power (no dmx in, etc.) - and to further clarify, JUST power on the LEFT input as looking with the power connectors towards the bottom of the board, I get channel 6 LED lighting up. The LEDs all function and I see Lynx Express scroll across.
Channel 6 stays lit. All boards operate exactly the same way. Thoughts? Would this indicate the PIC is not programmed??
Note - I tried searching for "channel 6" but I was informed by the forum that all words must contain 2 characters. Grr...
For indexing purposes, Channel six stuck on.