DiyLightAnimation
Fun => The Porch => Topic started by: wheelyneil on March 06, 2010,
-
Hello Forum
I was watching a video on setting up the Lynx Dongle. There were 2 Items that were used in the testing. A RGB-Pixel and also a Power injector for a 12v supply.
The video is located here if you care to look at what I am speaking about.
DONGLE SET UP (http://www.vimeo.com/8593498)
My question is where do you buy these 2 Items or is there a new setup that has replaced them? ???
Thanks for any help in advance ;)
Neil
-
Neil:
In his video, Bill just used the RGB Pixel (and its associated power injector) as a test-bed for the dongle -- you can use any DMX device to check that the dongle is working.
It is something of a chicken-and-egg conundrum though -- if you've built a Lynx Express, for example, and a Lynx Dongle and haven't tested either against a known working device and they don't work, you will have a difficult time figuring out which is the broke one.
If you really want an RGB Pixel, they're at
http://response-box.com/
Though just looking around, it appears John doesn't have any to sell right now.
HTH.
\dmc
-
Thanks for the info, \dmc
I am new to all this and just was looking for some hardware to verify the circuits are working after a build. ;)
If anyone has a better way, drop me a line :P
take care, and thank you ;D
Neil
-
Thanks for the info, \dmc
I am new to all this and just was looking for some hardware to verify the circuits are working after a build. ;)
If anyone has a better way, drop me a line :P
take care, and thank you ;D
Neil
[/quote If you are talking about ver1 dongle what i did was after I built Ver 1 dongle I opened vixen and took note of com ports ( com1, com3 ) then i plugged dongle in and a new com port appeared com4 at least I new PC recognized dongle then I check output when I Built LE
-
Try this link. I built a similar one to test output from my dongle. Wont show you channel activity just that dongle has DMX output.
http://diylightanimation.com/index.php?topic=218.msg1801#msg1801
-
Thanks Lineman and Garyi
You know just a little info helps to get over humps you can run into.
I am building a Dongle right now and I just wanted a easy test platform after the solder cools :P
I take a few notes from these answers and it always helps.
Thanks, both answers helped allot, I can get a quick software look " I GOTTA READ A LITTLE MORE ON VIXEN"and also have a little hardware tool too ;D
Take care All
Neil