Hardware > Lynx MR16 / 16 CH DC Controller
MR16 and the Mighty Mini RGBW floods.
animal:
If I remember. The output from the 24v power supply was a little to hot for the voltage regulator. It met specs but ran real hot so a 47ohm x 10 watt block resistor was put in line going to the board. Seemed to cool things down. But my memory is vague. Mr16 should be fine.
animal
animal:
You are not allowed to view links.
Register or LoginWithout the mosfets you are really limited on the current and you need the alternate firmware. The mosfets invert the output.
--- End quote ---
So keep as is with the mosfets. correct?
combustionmark:
The Renard had mosfets, then I would use the MR16 with mosfets.
animal:
Ahhhhh! Got it.
thank you.
. animal
Ron:
I did not run the additional resistor with the 24v power supply last year and did not notice excessive heat. I'll have to check the wiki now.
Navigation
[0] Message Index
[*] Previous page
Go to full version