On the post above, it seems you have smart strings and DMX.
Which one's are you testing in the above when turning on the Output?
And what are the jumper settings for the hub?
I'm assuming you are setting the jumpers at 1 and 1 for the DMX set up on the hub
What are the actual addresses in LSP for each type of lights you are using, and do they match what you programmed them with the Smart String Utility?
For my Smart LED Flexstrips, the first set appears in LSP as Controller type: RGB light controller and ControllerProtocol: E.131 DMX over ethernet, channel numbers are 1 - 360 (there's 120 Nodes on my first lights.)
For my first DMX controllers, they appear in LSP as controller type: Light Controllers, Controller Protocol E1.31 DMX over Ethernet.
Now, for DMX channel numbers, they are numbered as 3898 - 3913 in LSP, but their physical DMX address is set to 314 - 330.
This is because I have selected DMX universe 8, which starts at logical address 3584. However, the hardware DMX addresses can only be between 1 and 512. Note, that I used the utility to program their DMX addresses as 314 - 330 to match what is set on the hub jumpers.