I have two EthD. both work as EDs and run the lights no problem. I flashed one with the Conductor 14 firmware, installed the Conductor, Programmed the CF card and powered up. The green light on the ED is always on. The red light on the conductor is always on. The green and yellow lights on the Magic Jack blink as would be expected but, it will not connect. I always get not connected when i start up the control panel. So, I built up the second conductor. The second one also comes up not connected. So I removed the CF card on each of them. No message that the CF card is absent. I cannot seem to get by the not connected message. An suggestions would be appreciated. The same cables and hub run the lights, so I do not think they are the problem. I reflashed the firmware, no help.
I guess the minimum I need to get going is a CF card absent message.
Rick S