Ok, Here is how to load the boot loader on the Beta Panther. You must have a working arduino to to this. Follow the steps below
1.) Install this sketch on your arduino. You are not allowed to view links.
Register or
Login2.) Us this photo to setup the 6 required wires on your Beta Panther. You are not allowed to view links.
Register or
Login 3.) Connect the wires as described below from the Beta Panther to the Arduino.
Panther Arduino Pin
White - Green Stripe 10
Brown Ground
Green 5V
Blue 11
White - Orange Strip 13
White - Blue Strip 12
Do not hook up the to the arduino until you have the sketch loaded to the working arduino.
After you have completed all the above from the arduino ide under "tools > programmer" select "Ardunio as ISP". Then select tools burn bootloader.
Once you have done that then put the panther chip in the ardunio and run avrdude to load the sketch. Here is the command I used to load.
C:\arduino-1.0.2\hardware\tools\avr\bin>avrdude -V -F -p m328p -carduino -P com4 -CC:\arduino-1.0.2\hardware\tools\avr\etc\avrdude.conf -U flash:w:PantherDMXPlayerB3.hex -vvv