DiyLightAnimation
Hardware => Lynx Express => Topic started by: ratroder on February 21, 2010,
-
does the lynx express need to be programmed? which ic needs to be programmed? could i hook a pic unit to the assembled controller and program it that way?
-
If you are getting the parts in a COOP then no, The pic is programmed for you. You only have to set the start address using the on-board push buttons or by using the lynx conf program.
If you get the parts yourself then Yes the Microchip PIC24FJ32GA002SP needs to be programmed.
Rick R.
-
sadly i missed the last coop :-\. ok, could i program that ic while it is on the board using a pic unit or does it have to be programed separately?
-
sadly i missed the last coop :-\. ok, could i program that ic while it is on the board using a pic unit or does it have to be programed separately?
Yes the LE has a ICSP header to allow programming of the pic. Just put a Pickit2 or Pickit3 on the header and send the hex code to it. Hex code is in the wiki
Rick R.
-
Greetings,,,
It shows, in the manual, the pic being programmed on board by the Pickit programmer. I've done it many times.
Keith